# Changelog
Changes in each firmware release are documented in this file.

## [2.0.5.p.777] - 2023-03-27
### Fixed
- MIDI CC 22 (modulation rate) range was incorrect.
- Blend L/R tilt did not behave correctly with mono in/stereo out.
- Right LED occasionally blinked green in bypass.

## [2.0.4.p.452] - 2022-05-06
### Fixed
- Version 2.0.3 introduced a volume boost.
- LFO rate was sometimes audible with amp volume up and not playing.
- Eliminated dropout when saving a preset.
### Added
- Restores last preset selected via preset button on startup.

## [2.0.3.p.359] - 2022-02-01
### Fixed
- Changing Input/Output Configuration while in ping pong mode did not
  update left/right ping pong routing.
- Periodic low-level white noise with low feedback settings and
  plugged direct into certain amps.
- Shift mode switch did not always send MIDI CC when moved.


## [2.0.2.p.262] - 2021-10-28
### Changed
- Saves config settings immediately.  Previous firmware versions used
  delayed write, which could cause changes to be lost if the pedal was
  unplugged before the save finished.
- LED blinks green when config settings are saved.
### Fixed
- Modulation waveform was not restored going from a preset to live settings.
- Modulation phase was not always restored going from a preset to live settings.
- Shift mode was not always restored going from a preset to live settings.

## [2.0.1.p.257] - 2021-10-23
### Fixed
- Tap tempo intervals were calculated incorrectly.
- Delay note divisions were not restored on startup.

## [2.0.0.p.248] - 2021-10-14
- Initial release of Raster 2.

## [1.0.1.p] - 2017-09-07
### Changed
- Detune up maximum changed from minor third to major third.
- Changed shift pot scaling.

## [1.0.0.p] - 2015-05-01
- Initial release of Raster 1.

