Posts Tagged “diy”

3D-printed pedal cover

Here's a cover to protect your Red Panda pedals from dust and liquids.  It is not snap-tight, but in a pedalboard gig bag or with a couple rubber bands it will also protect the knobs during shipp…
Continue Reading ›

3D-printed guitar pedal stand

Here's a 3D-printed guitar pedal stand that holds one Red Panda pedal at a 30 degree angle.  It is 3" wide with a 4.6" hold depth, so it will also work with MXR and 125B sized pedals.  I des…
Continue Reading ›

Tensor v1.1 and remote switch

We just released a Tensor firmware update with some new features that are accessible via USB MIDI or a remote footswitch:Loop sampler functions (retrigger / stop / one shot)31 presets via USB MIDI or…
Continue Reading ›

Replacing Particle Footswitch

The Particle uses a standard 3PDT latching bypass switch.  To replace a broken or worn out footswitch, follow the wiring in the diagram below. You can also use the Mammoth Electronics Large…
Continue Reading ›
Loading...